Versa-matic Liquid Level Control Manuale Utente Scaricare il pdf

Versa-Matic

Liquid Level Control

032.V036.000

VERSA-MATIC

• Warren Rupp, Inc. • A Unit of IDEX Corporation

800 North Main Street, Mansfield, OH 44902 USA • Phone: (419) 526-7296 • www.versamatic.com

Original Instructions

Service & Operating Manual

Features & Benefits:

• Completely automatic operation.

• Easy, low-cost installation. The control is plumbed as

part of the piping system.

• All pneumatic operation - no electrical connections.

• Versatility. One control can be installed to handle

sumping and tank filling/transfer.

• For sumping operations, the pump is started at a high

liquid level, and stopped at a low liquid level. For tank

filling and transfer, the pump is started at a low liquid

level and stopped at a high liquid level. It’s completely

adjustable to any liquid level operating range. It will

adjust from a few inches to approximately nine feet.

• Long life operation. Corrosion-resistant wetted parts.

• High capacity air valve. Accomodates air flow

requirements up to 125 cfm, with a pressure drop less

than 10 psi.

How It Works:

This liquid level control operates entirely by mechanical

and pneumatic means. A float-operated air pilot valve

controls the opening and closing of an air valve. It admits

or exhausts air through a special regulator to turn an air-

operated pump on or off.

Installation:

The line air valve and air pilot valve are

preassembled on bracket and ready for mounting to

1½1/2” (3.81cm) standard on pipe.

Unit is ready as recieved for standard (high level on

- low level off) operation. For reverse operation (low level

on - high level off), remove bracket (item 1) from pilot valve

by removing hex nut (item 12). Install bracket opposite

direction from position shown and action is reversed.

Install float and rod as shown and mount rod guide

bracket below control as required. A minimum of 10 PSI

(.6895 BAR) air pressure is recommended for operation

of liquid level control.

Air In and Air Out are noted on the regulator.

Note:

Important - a minimum of 8 PSI, created through pump

application, must exist for the float valve to work.

a c c e s s o r i e s

Versa-Matic’s float actuated air valve and liquid level control provides all pneumatic operation.

Especially useful in sumping and liquid transfer situations, the float actuated switch opens and closes air

supply to the pump for positive ON-OFF response.

1 2 3 4

Sommario

Pagina 1 - Versa-Matic

Versa-MaticLiquid Level Control 032.V036.000VMVERSA-MATIC® • Warren Rupp, Inc. • A Unit of IDEX Corporation 800 North Main Street, Mansfield, OH 4490

Pagina 2 - ½ NPT AIR PORTS

www.v ersam atic.c om2 • Liquid Level Controlvmllcsm-rev0513Liquid Level Control16517182414 15631792QTAIR INLET1219138137161717173181792112193TO PUMP1

Pagina 3

www.v ersam atic.c omLiquid Level Control • 3vmllcsm-rev0513Float Actuated Air ValveGrounding the Liquid Level Control16517182414 15631792QTAIR INLET1

Pagina 4 - EC Declaration of Conformity

In accordance with ATEX Directive 94/9/EC, ANNEX VIII, Equipment intended for use in potentially explosive environments.II 2 G D T5David Roseberry, En

Commenti su questo manuale

Nessun commento

Versa-matic Liquid Level Control Manuale Utente

Navigare online o scaricare Manuale Utente per Hardware Versa-matic Liquid Level Control. Versa-Matic Liquid Level Control User Manual Manuale Utente

Sommario

Commenti su questo manuale

Prodotti e manuali riguardandi Hardware Versa-matic Liquid Level Control